Evs XSnano Version 11.02 - July 2012 Configuration Man Bedienungsanleitung PDF herunterladen (Seite 145)

3.8.3. Tally Settings

Introduction

The Tally settings allow specifying the settings related to the tally feature. This feature

allows the user to automatically create a clip for each change of camera performed with

the Director’s Cut and to add these clips to a playlist. The clips are created automatically

by the server as it receives GPIs IN signals from a switcher when the director changes

the camera angle.

User Interface

These fields are available in the following interfaces:

• in the Multicam Configuration window, GPI tab

• in the Technical menu of the Remote Control Panel (T6.X)

The following screenshot presents the settings page of the Monitoring tab in the server-

based application and highlights the Tally settings area.

How to Activate the Tally Function

To use the tally function, proceed as follows:

1. Activate it using the Tally parameter.

2. Go to the GPIs IN settings area and select the GPI IN used for the tally control.

3. Set the Channel/Device on the REC on which the Director’s Cut is performed.

4. Set the function as Mark Tly.

CONFIGURATION MANUAL XSnano Server 11.02

3. Multicam Configuration 137

1 2 ... 140 141 142 143 144 145 146 147 148 149 150 ... 173 174

Keine Kommentare

Evs XSnano Version 11.02 - July 2012 Configuration Man Bedienungsanleitung Seite 145